Epoxy Flooring in Valrico, FL

Epoxy flooring in Valrico tends to start with a family garage. Wikipedia counts 13,708 households here, and 60.2% of them are married couples, which is a high share for the area. Garages in town do a lot: bikes, a second fridge, sports gear, a car or two, and sometimes a home gym. A coated floor makes all of that easier to keep clean, and it stops the dust that bare concrete sheds.

Built mostly in one era

Valrico had 6,582 residents in 2000 and 35,545 by 2010, according to the census numbers on Wikipedia. That means a lot of local garages were poured in the same ten years with similar methods. Many are in good shape, but they often have shrinkage cracks along control joints and some surface wear where cars turn in. We grind, fill and level those areas so the finished floor looks even.

A little higher than its neighbors

Valrico sits at about 102 feet above sea level, higher than much of Hillsborough County. Higher ground does not always mean a dry slab, though. Irrigation, gutters that drain toward the garage and Florida's water table can all keep concrete damp. We test every slab, because a coating is only as good as the moisture conditions beneath it.

Get a Free Estimate

Cold snaps are part of local history

A major freeze in 1895 halted Valrico's early development, and inland east Hillsborough still sees cooler winter mornings than the coast. For a floor, that mainly affects cure time. On a chilly day we start later, warm the space if needed and use products that cure at lower temperatures.

Picking a finish

• Full flake hides tire marks and dirt and adds grip for kids running through.
• Polyaspartic topcoat resists UV and hot tires, good for a west-facing door.
• Metallic epoxy suits a garage converted into a game room or office.

Weathering the 2024 storms

During Hurricane Milton, a CoCoRaHS rain gauge 2.2 miles southeast of Valrico recorded 11.11 inches over two days, per NWS data. Water can enter a garage under the door during a storm like that. We can add a small cove at the base of walls and seal the joint where the slab meets the stem wall, which makes cleanup simpler after heavy rain.